Follow the following steps to attach Watermark sensors to your Outpost using 3M™ Scotchlok UY2 Connectors.
- Do not strip the insulation off sensor or logger wires
- Insert 1 green wire from watermark sensor and 1 wire from Outpost (red or blue) fully into Scotchlok connector, so it visibly hits the end of the connector. You can see this through the clear back of the connector.
- Using pliers or the scotchlok E-9 tool, squeeze the connector, so that “button” fully enters the body of the connector (see pic). Best to squeeze once from one side of the Scotchlok, then again from the other side to ensure it is evenly seated. A small amount of waterproofing gel may exude from the connector openings, but this is normal.
- Repeat for the remaining set of wires.